How to Install Drip Edge on Shed Roof: A Step-by-Step Guide

The drip edge is an essential component of any shed roof as it helps to protect the roof decking and fascia board from water damage. If your shed roof doesn't have a drip edge, it's important to install one to ensure that your shed stays protected from water damage. In this guide, we will provide you with a step-by-step guide on how to install a drip edge shed roof.

Step 1: Gather Your Tools and Materials

Before you begin the installation process, it's important to make sure you have all the necessary tools and materials. For this project, you will need:

Drip edge
Hammer
Roofing nails
Tin snips
Measuring tape
Caulk

Step 2: Measure the Length of the Shed Roof

To determine how much drip edge you need for your shed roof, you need to measure the length of the roof. Start at one corner of the shed and measure all the way to the other end. Be sure to add a few extra inches to account for any overhangs.

Step 3: Cut the Drip Edge to Length

Using your tin snips, cut the drip edge to the length you just measured. Be sure to wear gloves and safety glasses when cutting the drip edge as the edges can be sharp.

Step 4: Install the Drip Edge

Starting at one corner of the shed roof, place the drip edge along the edge of the roof with the long edge facing down. Make sure that the drip edge extends past the roof decking by at least 1/4 inch. Secure the drip edge to the roof decking with roofing nails.

Step 5: Continue Installing the Drip Edge

Continue installing the drip edge along the length of the roof, making sure to overlap the ends of each piece by at least 1 inch. When you reach a corner, cut the drip edge to fit the corner and secure it in place with roofing nails.

Step 6: Seal the Joints

Once you have installed all of the drip edges, it's important to seal the joints to prevent water from seeping through. Use caulk to seal the joints where the pieces of drip edge overlap.

Step 7: Inspect Your Work

After you have finished installing the drip edge, inspect your work to make sure that everything is secure and in place. Be sure to check that the drip edge is extending past the roof decking by at least 1/4 inch.

Installing drip edge on a shed roof is a simple process that can help to protect your shed from water damage. By following these steps, you can ensure that your shed roof is properly protected from the elements.